Installer Mode; Setting Parameters - EQUATION TH200M Manual De Instrucciones

USE
FR
Functions and Displays
Temperature display
ES
Displays the room temperature
or the set temperature (fl ashes)
PT
Set temperature
IT Displayed while viewing or adjus-
ting the set temperature.
EL
Defect indicator
Flashes to indicate a thermostat
fault.
PL
Contact a qualifi ed technician.
UA
RO
EN
-
+

Installer Mode

The thermostat is factory set to control a gas boiler. Installer Mode allows you to modify these factory
settings respecting the above values.
Access to installer mode:
Reading
parameters:
Setting
parameters:
30
Low Batteries
Flashes to indicate that the
batteries need to be replaced.
Test button
Press to force the boiler to start
in order to check the correct
connection.
Press again to exit test mode.
+
-
Heating indicator
Lights up when the thermostat
starts the boiler.
2 s
Adjustment buttons
Press once to display the
set temperature (desired
temperature). Press several
times to adjust the setpoint
temperature.
On / Off (Frost protection)
Press for 2 seconds to switch to
Frost protection mode, i.e. with a
setpoint temperature of 5 ° C.
Press again for 2 seconds to
return to normal mode.
Off / Frost protection
Displayed when the thermostat is in
Frost protection mode, i.e. with a setpoint
temperature of 5 ° C.
3 s