Uline H-7096 Manual Del Usuario página 4

WARNING! Disconnect power before cleaning
or maintaining fan in order to prevent serious
injury or death.
• Some maintenance procedures may require
removal of fan guarding.
• After servicing, guards and other safety
devices must be reinstalled to their original
condition.
• Excessive dust and debris may cause
overheating and reduced fan performance.
• Keep guards, motor and blades clean by
vacuuming or wiping with a damp cloth.
OPERATING ISSUE
Fan does not operate.
Insufficient airflow.
Excessive noise.
Excessive vibration.
PAGE 4 OF 12
MAINTENANCE
TROUBLESHOOTING
CAUSES
Fan is not plugged in.
Blown fuse or tripped circuit
breaker.
Defective on/off switch.
Defective motor.
Fan blade contacting housing.
Guards excessively dirty.
Blade and motor excessively
dirty.
Fan blade contacting housing.
Defective motor bearings.
Loose guards.
Damaged fan blade.
Motor shaft is bent.
Motor is loose.
1-800-295-5510
uline.com
• Do not use harsh chemicals or cleaners to
clean any part of the fan.
• Pressure washing the unit will void the
warranty.
• Sealed motor bearings are pre-lubricated
and do not require servicing.
RECOMMENDATIONS
Check power cord connection.
Replace fuse or reset circuit
breaker.
Repair or replace switch.
Repair or replace motor.
Realign fan blade in fan housing.
Clean inlet and outlet guards.
Clean blade and motor.
Realign fan blade in fan housing.
Repair or replace motor.
Tighten guard fasteners.
Replace fan blade.
Repair or replace motor.
Realign if necessary and tighten
fasteners.
0821 IH-7096