Cleaning - Elite HG1600 Manual De Usuario

Check before powering on
Warning
Risk of injury! The tool should only be put into operation if it is in perfect condition. It is crucial that defective
parts be replaced before the product is used again.
Check the safety conditions of the product:
- Check that the air inlet openings are not blocked.
- Check all parts, make sure they t properly.
- Check for visible defects: broken parts, cracks, etc.
On o
NOTE
Risk of product damage! Always keep a minimum distance of 25 mm between the nozzle and the surface to be
treated.
NOTE
Danger of product damage! Never use the product with the air inlet openings pointing down. Dirty air can be
sucked in.
NOTE
Danger of product damage!
The product must always be used with one of the nozzles.
WARNING!
Risk of injury! Use the bracket (F) to put the device to rest. Do not place the device on any ammable surface.
- Fit the required nozzle (②).
- On / O (③)
- Adjust the temperature by turning the temperature regulator (C) ④. The set temperature is shown on the
display (D)
- As soon as work has been completed, disconnect the plug from the mains and place the product in its holder
(F) so that it cools (⑤).
Cleaning and maintenance
WARNING!
Risk of injury! Turn o the product and disconnect the power plug before performing any
cleaning and maintenance. Wait until all moving parts have come to a complete stop and the
product has cooled down.
7
Keep Working