Descargar
Compartir
Imprimir esta página
  1. Manuales
  2. Marcas
  3. Waypoint Manuales
  4. Muebles de Interior
  5. SUC36T
  6. Instrucciones de instalación

Waypoint SUC36T Instrucciones De Instalación

Ocultar thumbs
1
2
3
4
5

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Descargar este manual
SHELF UNDER CABINET
INSTALL INSTRUCTIONS
SPECS. GUIDES. DETAILS.
It is the responsibility of the designer and installer to order the correct doors,
hardware and any required moldings and accessories. Waypoint Living Spaces®
cannot foresee every design contingency and cannot be held responsible for
incorrect door sizes, improper installation or other design or installation problems.
Waypoint® provides these drawings as a design suggestion only and disclaims any
and all liability. These solutions may or may not be suitable for your application.

Publicidad

loading

Resumen de contenidos para Waypoint SUC36T

  • Página 1 Waypoint® provides these drawings as a design suggestion only and disclaims any and all liability. These solutions may or may not be suitable for your application.

  • Página 2: Installation Instructions

    Measure the Frame width of the cabinet under which the shelf unit will be installed. • Tape Measure When finished, this will be the overall width of the SUC36T unit. If the cabinet is • Hammer 36” wide, go to the Assembly Procedure section of this document. Otherwise continue •...
  • Página 3 These marks will be needed later in the installation 3/8" (2 Places) process. Hold or clamp the SUC36T in the desired location under the wall cabinet that it is to be mounted to. Using a 3/32” drill bit, drill two pilot holes approximately 1-1/2” deep Pilot Hole through the above wall cabinet bottom and into the SUC36T.

  • Página 4: Estante Debajo Del Gabinete (Suc36T)

    Mida el ancho del marco del gabinete debajo del cual el estante va a estar instalado. Cuando • Martillo tenga esta medida, esta va a ser el ancho total de la unidad SUC36T. Si el gabinete tiene 36” de • Destornillador Phillips ancho, consulte la sección de este documento sobre el proceso de ensamblaje.

  • Página 5: Ensamblaje

    Figura 5 profundidad a través de la parte posterior de la SUC36T y en cada uno de los montantes que se habían marcado en el paso 1. Vuelva a poner la unidad en el lugar deseado. Vea la figura 5.