Publicidad
Idiomas disponibles
Idiomas disponibles
THESE INSTRUCTIONS SHOULD NOT BE FAXED OR REPRODUCED ON A DIGITAL COPIER. AMERICAN WOODMARK CORPORATION PROVIDES THESE INSTRUCTIONS ON AN "AS IS" BASIS AND DISCLAIMS ANY AND
ALL LIABILITY FOR ANY INACCURACIES, OMISSIONS OR TYPOGRAPHICAL ERRORS CAUSED BY ANY THIRD PARTY'S EQUIPMENT. When you use these instructions, you are consenting to be bound by the provisions
in this paragraph. These instructions provide an illustrative method for installing American Woodmark Corporation ("AWC") cabinets and/or accessories. AWC's instructions are not intended to address every possible
contingency that might be encountered during installation or to endorse the use of any particular tools. AWC HEREBY EXPRESSLY DISCLAIMS ALL LIABILITY FOR ANY CLAIMS FOR INJURY OR DEATH RELATED TO OR
BASED UPON THE USE OF THESE INSTALLATION INSTRUCTIONS AND ANY INSTALLATION INSTRUCTIONS OTHERWISE PROVIDED BY AWC.
Installation Instructions
Shelf Under Cabinet (SUC36T)
Provides open shelf storage below wall
cabinets up to 36" wide.
Contents
• (1) Back
• (1) Shelf
• (1) Front Rail
• (2) Side Panels–(1) Left and (1) Right
• (4) #6 x 3/4" Flat Head Phillips Wood
Screws
• (8) 1" 17 gauge brads (finishing nails)
Tools Needed
• Phillips Screwdriver
• Drill
• 5/32" & 3/32" Drill Bits
• Wood Glue
• Countersink Bit (Optional)
• Pencil
• Tape Measure
• Hammer
• Saw
• Safety Glasses
Additional Items Needed (not included)
• (4) #8 x 1-1/2" Flat Head Phillips Wood
Screws
SPECS. GUIDES. DETAILS.
Procedure
3/4"
7/8"
1/2"
3/8"
1"
5/8" Dia. Drill
3/16"
Figure 1
Trimming
Measure the Frame width of the cabinet under which the shelf unit will be installed.
1
When finished, this will be the overall width of the SUC36T unit. If the cabinet is
36" wide, go to the Assembly Procedure section of this document. Otherwise continue
to Step 2.
The back, front rail and shelf pieces will need to be cut to the correct size for your
2
installation. They should each be 3/4" less in length than the overall width of the unit
determined in Step 1. Measure and mark each piece at the determined length and
complete the cut on each piece.
On the newly cut (trimmed) end of the front rail, cut the notches in the front rail to
3
match the notches on the opposite (untrimmed) end. See Figure 1.
On the newly cut (trimmed) end of the back, drill two holes using a 5/32" drill bit to
4
match the holes on the opposite (untrimmed) end. See Figure 1.
On the newly cut (trimmed) end of the shelf, cut the notches in the shelf to match the
5
notches on the opposite (untrimmed) end. See Figure 1.
Continued on the next page
Read carefully before you begin installation
1"
3/8"
1/2"
99896 8/07
Publicidad
