Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING
ATTENTION: be cleaned before installation of
the new wheel hub/bearing unit, the contact
surface in the wheel bearing housing.
Mount the mounting shells to the new wheel
hub/bearing unit with the fastening bolts for the
mounting shells.
Lay the new hub/bearing unit onto the mounting
plate so that the pre-assembled bolts touch the
mounting shells through the wheel stud holes.
Attach the mounting plate sideways to the drive
shaft and lead the spindle with the attached
mounting plate and new hub/bearing unit from
the front through the swivel bearing and the
mounting plate.
Pull in the new wheel bearing with the bearing
spindle and the spindle nut.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
