Warranty Disclaimer - Hama DIT1010BT Instrucciones Breves

Note – switching on for the rst time
• The Setup Wizard starts up automatically when the
radio is turned on for the first time.
• The default used language is English.
• You can skip the Wizard and start it up again later in
German.
5.3 Language
The first time it is used, the tuner's default language is
English. To change tuner's menu language, proceed as
follows:
• Press [ ] (6) to access the Settings menu.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to navigate
to the "Settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (9).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to navigate
to the "Language" menu item. Confirm the selection by
pressing [POWER/VOLUME/ENTER/NAVIGATE] (9).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (9) to select
your preferred system language.
• The language setting currently selected is marked with
an asterisk (*).
Note
• The following languages are available:
English, German, Danish, Dutch, Finnish, French,
Italian, Norwegian, Polish, Portuguese, Spanish,
Swedish, Turkish
6. Connections
Note
• Connections that are established by means of an
optical signal cable are less affected by electrical
or magnetic interference than connections that are
established via a 3.5 mm audio cable.
6.1 Connection via Optical OUT
You can connect your loudspeaker to the tuner via the
digital audio output, for example, and play its audio
signals via the loudspeaker.
Note
• Switch the tuner off before connecting a device to it.
• Before connection, remove the safety caps from both
ends of the optical signal cable.
• Do not bend or crush the cable.
• For playback via the optical audio connection, connect
an optical signal cable to the tuner's optical audio
output (3) and the loudspeaker's optical audio input.
• Press [POWER/VOLUME/ENTER/NAVIGATE] (9) to switch
on the tuner.
• The tuner's audio signal is now output via the
loudspeaker.
6.2 Connection via LINE OUT
You can connect your loudspeaker to the tuner via the
analogue audio output, for example, and play its audio
signals via the loudspeaker.
Note
• Switch the tuner off before connecting a device to it.
• Do not bend or crush the cable.
• For playback via the analogue audio connection,
connect a 3.5 mm RCA cable to the tuner's analogue
audio output (2) and the loudspeaker's analogue audio
input.
• Press [POWER/VOLUME/ENTER/NAVIGATE] (9) to switch
on the tuner.
• The tuner's audio signal is now output via the
loudspeaker.
7. Care and Maintenance
• Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
• If you do not plan to use the product for a prolonged
period, turn off the device and disconnect it from the
power supply. Store it in a clean, dry place away from
direct sunlight.

8. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
7