Delabie TEMPOSTOP Manual Del Usuario página 12

• THE INTEGRITY OF THE SEALS BETWEEN THE STAINLESS STEEL
WALL PLATE AND THE WALL OR THE WALL PLATE AND
THE MIXER/TAP/VALVE AT LEAST ONCE A YEAR, AND MAKE
GOOD IF NECESSARY.
If this advice is not followed, water may leak into the wall.
DELABIE cannot be held responsible for any ingress.
FOR FURTHER INFORMATION PLEASE CALL
DELABIE TECHNICAL SUPPORT UK: 01491 821821.
ALL OTHER MARKETS: +33 (0)3-22-60-22-74.
REMEMBER
• Our mixers/taps/valves must be installed by professional
installers in accordance with current regulations and recommendations
in your country, and the specifications of the fluid engineer.
• Sizing the pipes correctly will avoid problems of flow rate,
pressure loss and water hammer (see calculation table in our brochure
and online at www.delabie.com).
• Protect the installation with filters, water-hammer absorbers
and pressure reducers to reduce the frequency of maintenance
(recommended pressure: 1 to 5 bar, minimum 2 bar for siphon-
action urinals).
• Install stopcocks close to the mixer/tap/valve to facilitate maintenance.
• The pipework, stopcocks, bib taps and all sanitary fittings should
be checked at least once a year, and more frequently if necessary.
ADJUSTING THE FLOW RATE (certain models only)
The flow rate is set at the factory at 3 lpm for washbasins, 12 lpm
for showers (Ref.s fitted with ROUND, TONIC JET or GYM shower
heads are set at 6 lpm), and 0.15 l./sec. for urinals (ref.s 779128
& 779427 are set at 0.25 l./sec.).
The flow rate can be adjusted without shutting-off the water supply
or removing the mechanism.
Push-button control model (excluding through-the-wall) (Fig. H)
• Remove the coloured marker and adjust the flow rate
on the push-button using a 3mm Allen key.