Camera Positioning - Elinchrom Ringflash 3000 Manual De Instrucciones

Camera Positioning

3
1.
2.
3.
4.
5.
6.
The Ringflash can be mounted to a stand by using one of the two threads [2] and [3],
(1/4" and 3/8", respectively).
The camera lens is to be led through the opening of the Ringflash and then correctly
positioned and carefully fixed by using screw [6].
If a 3/8" screw is required, the screw can be exchanged. For doing this, unscrew and
reverse the screw [4] on both sides, remove the rail and insert the required screw.
Then re-mount the rail by screwing both screws [4].
The Ringflash unit can be vertically and horizontally shifted within the slots for precise
positioning of the camera by using screws [1] and [4], respectively.
The ring flash unit can also be operated without a stand by holding the handgrip [5].
1
2
4
Locking screw for vertical shift
Thread 1/4" for mounting to a stand
Thread 3/8" for mounting to a stand
Locking screw for horizontal shift
Handle
Screw 1/4" 3/8" for mounting the camera and left right shift of the camera
6
5
EN
5