Assembly; Exhaust Cover; Additional Handle; Clamping The Diamond Cutting Disc - Protool DCC-AGP 125 Manual Del Usuario

6

Assembly

WARNING
There is a risk of an electrical acci-
dent.
► Prior to any handling of the tool, unplug
it from the electric grid socket.
6.1 Exhaust cover – Fig. [2 a]
Before inserting the machine into the cover,
we recommend you to turn the machine
case by 180° with respect to the gearbox so
that the switch is on the right hand side – cf.
the instructions for the angle grinder.
Arrest the exhaust cover in the top position
and put in on the side, with the clamping
sleeve up. Then put the clamping neck [2-3]
of the grinder into the sleeve. Put the guiding
tabs [1-10] into the grooves on the clamp-
ing neck [2-3] of the grinder – detail A.
Turn the grinder counter-clockwise to the
suitable working position – cf. Fig. [2 b], set
the cover to the maximum cut-through and
arrest in this position. Tighten sleeve [1-9]
with screw [1-11] – Fig. [2 c]. When tight-
ening, be careful about the correct right-
angle setting of the grinder's bearing cover
in the exhaust cover's sleeve.
Disassembly of the exhaust cover
– Fig. [2 c]
The cutting disc must be dismounted before
the disassembly of the exhaust cover.
Set the cover to a cut depth of 10 mm and
put it down with the grinder at the bot-
tom.
Loosen screw [1-11] of sleeve [1-9]. Set the
cover to the top position. Turn the guiding
tab [1-10] into the groove on the grinder's
clamping neck. The turning can be checked
– the corresponding mark is on the side of
the disc – Fig. [2 d]. Remove the cover from
the grinder's clamping neck [2-3].

6.2 Additional handle

The additional handle, which is a part of
the angle grinder, can be screwed into the
corresponding threaded opening on the left
or right hand side [1-13].
The additional handle [1-15] is provided
with a special VIBRASTOP equipment, which
reduces the vibrations.
7 Clamping the diamond
cutting disc
Fig. [2 e]
WARNING
Do not use quick-change nuts for
clamping the disc.
WARNING
Only use diamond cutting discs rec-
ommended by the manufacturer and
the prescribed fl anges included with
the cover and the grinder.
► Sintered cutting discs must not be used!
► Only discs with an allowed peripheral
velocity of 80 m.s
used.
Set the sliding stop for cut depth [1-5] on
scale [1-7] to a depth value of 10 mm. Push
the arresting button [1-1] and push the
cover in. Release the arresting button and
let the cover be arrested when it gets to
the set depth.
Unlock with button [1-8] and fully open the
disc cover.
Clean the fl ange [2-5] and clamping nut
[2-7], as well as the clamping faces of the
cutting disc [2-6].
Put the fl ange [2-5] on the grinder's spindle
with the shoulder facing outward.
Put on the disc [2-6]; take care to comply
with the prescribed direction of rotation (ar-
row on the disc vs. arrow on the machine).
The fl ange shoulder must exactly fi t in the
disc's opening.
Screw on the clamping nut [2-7] with the
shoulder facing outward (from the disc),
press on the spindle arrest (cf. the instruc-
tions for use of the grinder) and tighten
with wrench [2-8].
Close the disc cover.
Before switching on, check free rotational
movement of the disc.
and higher can be
–1
15