Conceptronic CKVM2M Guía De Iniciación Rápida página 6

ENGLISH
This all in one KVM switch with built in KVM cable kit does not need extra
KVM cables.
There is no software needed and video resolutions up to 2048x1536 at
400Mhz bandwidth is supported.
With a simple hot-key combination you can select the computer and your
keyboard status will be restored when switching between the computers.
The LEDS at our KVM switch will inform you about the status.
1. Hardware Installation Conceptronic KVM Switch
Please turn off all your devices (computers, monitors etc.) before installation
of the Conceptronic KVM Switch.
To have the KVM switch work correctly you have to connect the cables of
your Mouse, Monitor and Keyboard to the KVM switch
The keyboard cable in the purple connector, the mouse cable in the green
connector and the VGA (Monitor) cable in the blue connector.
Now you can connect the cables of the KVM switch to your computer.
The Green connector is your mouse cable and the purple one is your
keyboard cable.
Note: do not use the hotkey function during boot-up process of your
computer
2. Usage
Normally there is one LED lit when the KVM switch is connected to a
computer. When you select one of the two computers with the hot key
combination the selected port will flash.
6