Homewerks 7141-50 Manual Del Usuario página 8

EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS
3. Unplug the fan power unit. Remove three screws on
the side of the fan housing that hole the fan motor
assembly in place. Remove the fan motor assembly
from the fan housing.
4. Remove wiring box cover from fan housing with a
Phillips screwdriver (not included).
5. Pull the house wires through the wire box cover hole
(6A). Using a quick connector, secure 120 V AC house
wiring from the wall switch to the fan (6B) as shown in
the wiring diagram on page 5. 14 AWG is the smallest
conductor that should be used for branch circuit wiring.
Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover.
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house wire
represents before connecting. You may need to consult
an eletrical contractor to determine safely.
6. Install a circular 4 in. duct (not included) and secure
it with duct tape or clamps (neither included). Finish
ceiling work.
3
4
5
6
8
Fan
housing
Quick
House
connector
wires
Product
wires
Fan housing
4 in.duct
Duct tape
or clamp
Ceiling