Decoder Installation
The following work steps may only be done in a voltage-free
work environment:
• Plug the cable included with the decoder (pay attention to the
track system) in the socket provided for it – see page 36/37
(Märklin and Trix). Now follow the illustrated instructions.
See the section "CV Programming" for changes to other charac-
teristics in the fx (MM) protocol using CV programming or to the
DCC CV programming.
Note: Settings with the DIP switches are to be only when the
voltage is turned off. The digital installation decoder does not
recognize the current switch settings until the voltage is turned
on.
Starting on page 38 you'll find the table for setting addresses
with DIP switches.
See page 28 for installation of the digital installation decoder
in Märklin standard turnouts, curved turnouts, or double slip
switches.
Alternative Power Supply page 31
See page 29 for installation of the digital installation decoder in
Trix standard turnouts, curved turnouts, or double slip switches.
Alternative Power Supply page 31
8
Disposal
Information about protecting the environment:
Products marked with a trashcan with a line
through it may not be disposed of at the end of
their useful life along with the normal household
trash. They must be taken to a collection point
for recycling electrical and electronic devices.
The symbol on the product, the instructions, or the packaging
indicates this. Depending on their description, the raw materials
can be used again. You make an important contribution to the
protection of our environment with the recycling of this material
from old devices. Please inquire in your community about the
appropriate disposal site.
Warranty
The warranty terms are stated on the warranty card included
with this product.
• Please see your authorized Märklin specialty dealer or
Gebr. Märklin & Cie. GmbH
Reparaturservice
Stuttgarter Str. 55 - 57
73033 Göppingen
Germany
Tel: +49 7161 608 222 (only from outside of Germany)
E-mail: Service@maerklin.de