Re-Adjusting The Counterplate; Care; Storage; Help In Case Of Malfunctions - AL-KO Easy Crush MH 2810 Manual Del Usuario

Storage

3. Remove the counterplate and guide plate
(12/1) by loosening the three M8 nuts (12/4).
4. Loosen and remove countersunk head
screws M8x10 (12/2).
5. Remove and turn blade (12/3). Replace the
blades if both sides are blunt.
6. Secure blade (12/3) using the countersunk
head screws M8x10 (12/2) and turn or re-
place the second blade.
7. Then fit the counterplate and guide plate
(12/1) again and tighten the M8 nuts (12/4).
8. Finally fit and screw the shredder upper sec-
tion tight.
8.3 Re-adjusting the counterplate (LH 2810)
(07)
A worn or damaged cutting drum and counter-
plate may only be replaced by an authorised spe-
cialist.
To obtain an optimum shredding result and pre-
vent damage to the blade unit (07/3), the counter-
plate (07/2) must be readjusted at regular inter-
vals.
The counterplate must also be adjusted if materi-
al frequently becomes jammed between counter-
plate and blade.
With the motor running:
1. Turn adjusting screw (07/1) 1/6 turn to the
right (clockwise), until a slight grinding noise
can be heard and fine aluminium chips fall
from the ejector chute for a short period of
time.
2. The material to be shredded should now be
cut completely again.
8.4

Care

■
Remove dirt and material residues after ev-
ery use.
■
Do not clean the machine with running water
or high-pressure.
Malfunction
Motor does not start.
442981_b
Possible cause
Collector box missing or not
locked.
Mains socket (house installation)
defective.
Extension lead defective.
■
Do not use any cleaning agents or solvents.
■
Use a soft brush or cloth for cleaning.
■
To protect the inner side of the housing from
corrosion, spray it with a biologically degrad-
able oil.
9 STORAGE
Clean the shredder after its use. Store it in a dry,
lockable place out of the reach of children.
Perform the following tasks when storing during
the winter period:
MH 2810 (11/12)
1. Switch off the machine and disconnect it from
the mains power supply.
2. Wait for the cutting disk to come to a stand-
still.
3. Loosen locking screw (11/1) and remove
shredder upper section (11/2).
4. Remove coarse and wet material to be
shredded from the inside of the shredder.
5. Spray the shredder blades (12/3) with an oily
care spray.
6. Empty the collector box.
7. Finally fit and screw the shredder upper sec-
tion (11/2) tight again.
8. Store the shredder upright.
LH 2810
1. Switch off the machine and disconnect it from
the mains power supply.
2. Empty the collector box.
3. Store the shredder upright.

10 HELP IN CASE OF MALFUNCTIONS

NOTE For malfunctions that are not listed
in this table or that you cannot resolve yourself,
please contact our customer service.
MH 2810
Solution
Push collector box in completely and
lock it.
Use a different mains socket in the
house.
Inspect the lead and replace it, if
necessary.
25