How To Charge The Battery - FLIR Systems i5 Manual Del Usuario

battery compartment. Note: Do not
use conductive tools when doing this.
en-US
3 Push the battery into place.
4 Replace the cover to close the battery
compartment.

How to charge the battery

You must charge the battery inside the
camera for four full hours (or until the bat-
tery indicator displays a green light) before
you use the camera for the first time.
Charge the battery by connecting the
power supply to the power connector on
the camera. Note: The first time you charge
a factory-new battery you must turn on
and then turn off the camera after you
have connected the power supply to the
power connector on the camera.
1 Battery indicator
2 Power supply cable
Quick Start Guide
Follow this procedure to start immediately:
1 Remove the protective film from the
LCD.
2 Insert a miniSD™ Memory Card into the
card slot.
3 Push the On/Off button to turn on the
camera. Note: If the camera does not
start, push the reset button with a non-
conductive tool. The reset button is lo-
cated beside the battery connector, in-
side the battery compartment. Then
push the On/Off button again.
4 Open the lens cap by pushing the lens
cap lever.
5 Aim the camera toward your target of
interest.
6 Pull the save trigger to save the image.