Basic Center Configuration - Nice M-BOARD Instrucciones De Seguridad Y Advertencias Para Instalación, Uso Y Garantía

intermittently;
2- Choose which function you want to achieve by pressing or not one
or more times always watching the LED;
3- Choose button A or B on the remote control and press;
4- Now choose another button other than the first one and press;
5- Successfully configured control, perform a trigger test using both
buttons.
3rd CASE:
1- Press the LEARN button once and watch the LED flash 1 time
intermittently;
2- Choose which function you want to achieve by pressing or not one
or two times always watching the LED;
3- Choose button A or B of the remote control that will have this first
function, click;
4- Observe the flashing of the LED to know which function is
5- Choose which 2nd function you want to get by pressing or not
more times always watching the LED;
6- Now choose another button other than the first one and press;
7- Successfully configured control, perform a trigger test using both
buttons.
Note: In 3rd Case, the button should not be pressed twice for con-
firmation.
Erasing the transmitters:
With the PROG switch equal to the image above, hold down the
LEARN button (for 10 seconds ) until the LED flashes quickly and
releases.

14 - BASIC CENTER CONFIGURATION

NOTE: At each touch of the LEARN button the LED flashing is incre-
ased, that is, the panel adds the presses of the LEARN button, when
71
ENGLISH