LG 47LV35A Guía Rápida página 21

Setting the Picture ID
The Picture ID menu allows you to control all sets using the IR Receiver connected to Set 1.
The IR signal of the remote control is
transmitted through the RS232C cables
connected in serial mode.
When you set a Picture ID using the remote
control, you can only control the Set that
matches the Picture ID.
ex) For example, if you set a Picture ID to 2,
you can only control the monitor with the
Set ID 2.
If Picture ID is set to Off, you can control all
monitors at the same time.
2 x 2 Multi-Vision
IR Receiver
RS-232C
1
Press the red ON button on the remote control
to assign the Picture ID.
2
To change the Picture ID, press the ON button,
or the left and right arrow buttons continuously.
Picture ID
◄ Off ►
Close
Picture ID
Off
◀
Close
NOTE
For example, if the Picture ID is assigned to
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
For each set, you can change the settings
for the PICTURE, TIME, NETWORK and MY
MEDIA menus or the hot keys on the remote
control.
If you press the green OFF button for Picture
IDs, the Picture IDs for all sets are turned off.
If you then press any button on the remote
control, all sets will start working again.
Picture ID will be disabled while using the
MY MEDIA menu.
If Picture ID is set to Off, holding buttons
on the remote control will execute only one
action at a time.
21
INSTALLATION
▶