Össur MAUCH MKN01360 Manual De Instrucciones página 7

PROCEDURE FOR ENGAGING SWING ONLY MODE (Figure 7)
• Hyperextend the knee
• Raise the U-Lever
• Stance resistance is eliminated
PROCEDURE FOR ENGAGING MANUAL LOCK (Figure 8)
• Do not hyperextend
• Raise the U-Lever
• Unit is locked against flexion
MAINTENANCE
• Cylinders cannot be replaced in the field. For cylinder replacement
and/or repairs, send the knee joint in for service.
• Knee joints must be stored upright. Storing cylinders or knee joints
on their side will cause the cylinder to draw in air. Air can be bled
from the system by engaging Swing Only mode and cycling the
cylinder until all of the air has been eliminated.
• Clean the extension stops regularly to prevent dirt buildup that may
compromise the cylinder release. Use a blunt instrument and be
careful not to scratch the contact areas.
Do Not disassemble the knee joint or attempt your own repairs. If a
problem should arise, send the knee joint in for service.
CLEANING
Wipe the knee with a soft cloth moistened with a small amount of
kerosene.
Do not use compressed air to clean the knee. Air will force pollutants
into the bearings which may cause malfunctions and early deterioration.
Do not use any solvents stronger than kerosene. Do not immerse the
whole knee or pour solvent over the knee, which would damage the
bearings and seals.
COSMETICS
Do not use talcum powder to eliminate noise in the cosmetic cover.
It reduces lubrication, which may lead to malfunctions and early
deterioration of mechanical parts. Use silicone spray instead.
WARRANTY
Össur offers 24 months limited warranty on manufacturing faults for all
countries except for U.S.A offers 36 months.
MAUCH KNEE ACCESSORIES
®
Product No:
MKA01361
MKA01362
MKA01363
MKA01364
MKA01365
MKA01366
Caution! Avoid placing hands or fingers near moving
joints.
Description:
KNEE BALL, SCREW, BTN HEAD
COVER, FRONT
COVER, REAR
PLUG, SIDE
EXTENSION STOP, SOFT
EXTENSION STOP, HARD
7