Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
THERMOSTAT REGULATION SPECIFICATIONS
Thermostat Features
Thermostatic Range
55-100 °F (13-38 °C)
55-118 °F (13-48 °C)
STOP:
Do not install, replace, or in any way modify the gas valve or the appliance, unless
CERTIFIED and QUALIFIED as a Gas Appliance Service Technician on the appliance this
valve is used on. READ AND FOLLOW ALL INSTRUCTIONS.
INSTALLATION
Valve configuration inspection
The 630 Eurosit can have one inlet and one outlet plugged.
Inspect the control to determine which inlet and outlet are
plugged. The plugs use o-ring seals and are made of brass.
The replacement control must have the same inlet and outlet
plugged as the original control. Use a 5/16" (8 mm) Allen key
to remove and tigten the plug.
The replacement 630 Eurosit has an On/Off modulating
plug (fig. A) installed. To achieve similar performance as the
original control, remove the plug in the replacement control
using a Flathead Screwdriver and set aside. Remove the Min
Rate Screw (fig. B) from the original control and install it into the replacement control in the same
location.
When installation of this product begins...
1. Read all of these instructions carefully. Failure to follow instructionscould damage the product
or cause a dangerous condition.
2. Check the ratings given in the instructions and on the appliance to make certain that the control
is suitable for your application.
3. All operations of installation, calibration, conversion and regulation must be undertaken
exclusively by qualified personnel following the instruction specified in this catalog and those in
the instruction manual of the appliance in which the valve is installed.
4. After installation is complete, verify that the appliance operates as indicated in these
instructions.
a
b
c
2.7
2.7
1.8
4.5
4.5
2.7
b
Temperature
c
a
Minrate Screw Minrate Plug
Fig. A
Min Rate Screw
Fig. B
Publicidad
Tabla de contenido
