Axxess GMOS-MOST-01 Instrucciones De Instalación página 4

Installing the GMOS-MOST-01
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the GMOS-MOST-01 harness into the interface.
• Connect the GMOS-MOST-01 harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
Note: If using the ASWC-1, connect it after you initialize and test the GMOS-MOST-01,
with the key in the off position.
Initializing the GMOS-MOST-01
Attention: If the GMOS-MOST-01 loses power for any reason, the following step will need to be
performed again.
• Initialize the interface by turning the ignition on for 30 seconds, then turn the ignition back off,
then back on again.
Adjusting the GMOS-MOST-01
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• Locate the end of the GMOS-MOST-01 with the 16-pin harness with stripped leads.
• With a small screwdriver, adjust the potentiometer clockwise to raise the audio level;
counterclockwise to lower the audio level.
• Once at a desired level, the audio level adjustment is complete.
Axxess Integrate
Installation instructions for GMOS-MOST-01
axxessinterfaces.com
•
metraonline.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER