Software Update - Samsung HW-K360 Manual Del Usuario

FUNCTIONS

SOFTWARE UPDATE

Samsung may offer updates for the Soundbar's system firmware in the future.
If an update is offered, you can update the firmware by connecting a USB device with the firmware update stored on it
to the USB port on your Soundbar.
Note that if there are multiple update files, you must load them onto the USB device singly and use them to update the
firmware one file at a time.
Please visit samsung.com or contact the Samsung call center to receive more information about downloading update
files.
● This product has a DUAL BOOT function. If the firmware fails to update, you can update the firmware
again.
● Connect a USB device containing the firmware upgrade to the standard end of a USB standard jack to
USB Micro plug Adapter cable. Connect the USB Micro plug end of the cable to the USB jack on the main
unit.
● Updating firmware may not work properly if audio files supported by the Soundbar are stored in the USB
storage device.
● Do not disconnect the power or remove the USB device while updates are being applied. The main unit will
turn off automatically after completing the firmware update.
● After the update, all settings are reset to their factory default settings. We recommend you write down your
settings so that you can easily reset them after the update. Note that updating firmware resets the
subwoofer connection too.
If the connection to the subwoofer is not re-established automatically after the update, refer to page 17.
If the firmware fails to update, we recommend formatting the USB device in FAT16 and trying again.
● Once the software update is completed, turn off the product and then press and hold the ( p ) button on
the remote control for more than 5 seconds. "INIT" appears on the display and the unit is powered off. The
updgrade is complete.
● Do not format the USB device in the NTFS format. The Soundbar does not support the NTFS file system.
● Depending on the manufacturer, some USB devices may not be supported.
DIGITAL AUDIO IN DC 19V
(OPTICAL)
USB (5V 0.5A)
AUX IN
DIGITAL AUDIO IN
(OPTICAL)
USB (5V 0.5A)
AUX IN
30