Profile PCF-600 Manual De Instrucciones página 6

ENERGY CONSUMPTION METER
PCF-600
Thank you for purchasing this Profile product.
Please note: It is important that you read this
manual before using the product. And be sure
to save this manual for possible use later.
Please note
The Energy Meter must be charged before
use. After 15 minutes, the LCD screen will
be operational, but to fully charge the
battery, the device must be plugged into
the mains for at least 12 hours.
The Energy Meter is the easiest way for you to
measure the energy costs of connected
appliances.
Correct use
The measurement range of the Energy Meter
is 5W to 3680W. Exact measurement of values
below or above this range is not possible. Use
outside this range can overload and damage
the unit.
The Energy Meter was designed to monitor
and measure electric appliances.
The Energy Meter is approved only for use
with 230V AC.
Only 230V AC, 50/60Hz electric appliances
may be connected.
The maximum power of the connected loads
may not exceed 3680W (maximum
amperage 16A).
Use of the Energy Meter is only allowed
indoors in dry environments. Use in the
open air is strictly prohibited!
Always heed the instructions on the
identification label located on the connected
power cables.
Use other than that described above can
result in damage to the product and the risk
of short circuit, fire, electric shocks, etc.
The product as a whole may not be
converted or modified. The safety
instructions must be followed strictly.
Safety instructions
The manufacturers accept no liability for
damage to objects or persons that arises
from incorrect use or noncompliance with
the safety prescriptions. All damage claims
resulting in such cases are void.
The Energy Meter may only be connected to
regulated outlets (230V AC, 50/60Hz-
10/16A) with a ground.
The connected appliances may not use
more than 3680W (16A).
The operating temperature of the connected
appliance must be between 10º and 40º.
High temperatures, especially when
measuring high levels of electrical power,
can result in overheating and damage to the
Energy Meter.
Avoid use in extreme weather conditions
and in the vicinity of inflammable gases,
moisture and dust.
For safety reasons, the unit may never be
operated in a wet or damp environment.
During cleaning or maintenance, disconnect
each source of power from the Energy
Meter. The battery and the LCD screen can
retain a charge, even when the unit is
disconnected from all sources of power.
Insert no metal parts or other objects in the
Energy Meter.
If it is established that safe use is no longer
possible, take the Energy Meter out of
operation and ensure that it is not
mistakenly put back into operation by
someone else. If there is visible damage to
the Energy Meter, it must be taken out of
service immediately.
Features
Display of current time (24-hour clock), day,
energy consumption in Watts and billing
rate.
Display of total time connected, energy
consumed and the cost of energy
consumed.
Display of total registered times, total time
and percentages.
Programmable day and night rates.
Configuration, connection and operation
The procedure for setting the time and the
billing rate is the following:
Setting the current time and
day
1. Simultaneously press the
"MODE", "+" and "-" buttons to
enter the system configuration.
The first setting is the current
time.
2. Use the "+" button to increase the value of
the flashing position from 0 to 9; use the "-"
button to decrease the value of the flashing
position.
3. Press the "MODE" button to move the next
position.
4. After setting the day, push the "MODE"
button again – billing rate 1 for the system can
now be configured.
Setting billing rate 1
(day rate)
1. Set the start time for
billing rate 1. For example
day rate starts at 7.00
a.m.
2. Set rate 1. For example
UK - 1