Profile PCF-600 Manual De Instrucciones página 7

ENERGY CONSUMPTION METER
PCF-600
10 cent per Kwh.
3. Use the "+" button to increase the value of
the flashing position from 0 to 9; use the "-"
button to decrease the value of the flashing
position.
4. Press the "MODE" button to move to the
next position.
5. Press the "MODE" button - billing rate 2 for
the system can now be configured.
Setting billing rate 2
(night rate)
1. Set the start time for
billing rate 2. For example,
the night rate starts at
9.00 p.m.
2. Set rate 2. For example
7 cent.
3. Use the "+" button to increase the value of
the flashing position from 0 to 9; use the "-"
button to decrease the value of the flashing
position.
4. Press the "MODE" button to move to the
next position.
5. Pressing the button for longer than 5
seconds will accept your settings and return
you to the display screen. If you only have 1
rate, set billing rate 1 to 00:00 and the cost per
KWh. Set the time for billing rate 2 to 00:00
and enter the cost per KWh.
Introduction to display screens
There are 3 display screens that contain three
different types of data. Use the "MODE" button
to select the type of screen you wish to view.
Display 1 Current time (24-
hour clock), day, current
consumption of the
connected appliance and
current cost per hour.
Display 2 Total registered time,
total energy consumed per Kwh
and cost per Kwh of actual
energy consumed.
Display 3 Total registered time,
total time worked and
percentage of time worked.
Resetting
Press "mode, +, -" for 5 sec. at the same time. All
measured data will now be reset.
The time and date will not be reset.
Technical data
Operating voltage: 230V AC (50/60 Hz)
alternating current (AC)
Maximum power of connected appliances:
3680 W
Maximum current: 16A
Input/ Output: via earthed socket
Operating temperature: + 10 to +40° C
Energy display: 0 kWh to 999.9 kWh
Maximum registration time: 9999 hours
Only use indoors (IP20)
Maintenance
Check the Energy Meter regularly for
damage.
Use only a dry, soft cloth to clean the unit
and the LCD screen.
Use no cleaning products.
Never immerse the unit in water.
Maintenance and repairs may only be
performed by technicians familiar with the
applicable regulations.
Guarantee conditions
The guarantee period for the PCF-600
amounts to 2 years and commences on the
date of purchase. During the guarantee period
ELTRA NV will repair any defects attributable
to material or production faults. Eltra NV may
choose to either repair or replace a defective
appliance.
ELTRA NV is not obliged to repair or replace
appliances if they have become defective as a
result of damage, inappropriate use, or
modifications or adaptations made after the
purchase date.
Take any defective appliance together with the
original receipt back to the shop where the
appliance was sold. Always add a note with a
description of the problem.
Damage
ELTRA NV can under no circumstances
whatsoever be held responsible for damage of
whatever nature if the appliance was not
correctly installed according to the specified
installation instructions, nor for damage as a
result of unforeseen circumstances such as
natural disasters, lightening strike, etc. All such
resulting costs are consequently at the
expense of the buyer and are not covered by
the guarantee conditions.
Eltra nv, Pachtgoedstraat 2, 9140 Temse, BELGIUM
Eltra DIYeuronet / Frontstraat 14 5405 AK Uden,
THE NETHERLANDS
www.eltra.eu
www.profileDIY.com
UK - 2