Before Installing The Range - Tappan TGF657BFW9 Instrucciones De Instalación

36 " GAS RANGE INSTALLATION INSTRUCTIONS

1. Before Installing the Range

Remove shipping material
Remove all tape, shipping and packaging materials and
the oven rack packaging. Lift up cooktop and remove
the two shipping screws from the cooktop burners (see
figure 2).
Figure 2
2. Provide an Adequate Gas Supply
This range is designed to operate on natural gas at 4" of
manifold pressure or on LP gas at 10" of manifold
pressure. It is shipped from the factory set for natural
gas. If it is to be used with LP gas, adjustments must be
made.
A convertible pressure regulator is connected in series
with the manifold of the range and must remain in series
with the supply line regardless of whether natural or LP
gas is being used.
For proper operation, the maximum inlet pressure to
the regulator must be no more than 14" of water column
(W.C.) pressure.
For checking the regulator, the inlet pressure must be at
least 1" water column pressure greater than the
regulator manifold outlet setting. If the regulator is set
for 4" of manifold pressure, the inlet pressure must be at
least 5". If the regulator is set for 10", the inlet pressure
must be at least 11".
The gas supply line into the range should be ½" or ¾"
I.D. flexible metal appliance connector five feet in
length.
3. Seal the Openings
Seal any openings in the wall behind the range and in
the floor under the range when hookups are completed.
4. Connect the Range to Gas
Refer to figure 4 to 7 for recommended connections.
A. Install a manual shut-off valve in the gas line in an
easily accessible location outside of the range. Be
sure you know how and where to shut-off the gas
supply to the range.
Screws
B. Install ½" flare union adaptor supplied with the
connector, to the ½" NPT internal thread on pressure
regulator.
Gas Connection for Electric Ignition Models
Flare Union Adaptor
Flexible Appliance
Connector
C. Because solid pipe restricts moving the range we
recommended use of A.G.A. design certified flexible
metal appliance connector. Connect flexible
appliance to flare union.
D. Move range into approximate position and connect
flexible appliance connector to gas supply line with
proper flare union adaptor. The adaptor supplied with
the flexible connector must be used.
E. Check for leaks. Turn the gas supply on the range
and use a liquid leak detector at all joints and
connections to check for leaks in the system.
3-Wire Polarized
120V. Outlet
3"
7
32
20"
or Lower
Recommended locations for installing the electrical
outlet and pipe opening may be adjusted to meet
specific requirements.
3
Pressure
Regulator
Figure 3
25"
" ± ¼ "
/
Gas Supply
8
Pipe
6 ¾ "
36"
36 ¼ "
Figure 4