Stuffer Assembly - Weston 33-0201-W Manual De Instrucciones

STUFFER ASSEMBLY

Entanglement Hazard. Disconnect power before cleaning,
w WARNING
disassembling, or assembling.
1. Remove the Ring Nut, Grinding Plate,
Knife and Auger from the Grinder Head
before installing the Grinder Head to the
Main Body.
2. Align the notches in the Grinder Head
with the tabs on the Main Body.
3. Press the Grinder Head against the
Motor and rotate it counterclockwise until it
locks into place (FIGURE F).
4. Insert the Auger into the Grinder Head,
Auger Driver end first (FIGURE G).
5. Place the Stuffing Spacer into the Grinder
Head. Make sure the notch of the Stuffing
Spacer fits into the positioning pin of the
Grinder Head.
6. Insert the Stuffing Funnel through the
Ring Nut and then onto the Grinder Head.
7. Turn the Ring Nut clockwise onto the
threaded end of the Grinder Head until it
touches the Stuffing Funnel. DO NOT over-
tighten the Ring Nut.
8. Place the Tray on the upright part of the
Grinder Head. NEVER use the Grinder
without the Tray installed!
Auger
Driver
FIGURE F
FIGURE G
11