Tabla de contenido
Publicidad
This includes the foam and the adhesive tape
from all outside and inside surfaces, as well as accessories and racks.
beverage center.
beverage center
beverage center:
beverage center.
beverage center,
See the WARNING in Electrical Requirements on the previous
page.
hours so that the interior is sufficiently cool before opening the door to place
bottles into the compartment.
Handle Installation
1
Handle Attachment
Shafts
Set Screws
Hex Key
1. Set the attachment shafts of the handle over the attachment posts protruding from
the door. To avoid turning unit over, attach handles with set screws facing up. If unit is
turned over to facilitate attaching handle so that screws will not be seen, you must wait
1 hour before plugging unit into power source.
2. Use a 3 mm hex key to securely tighten the set screws in the handle attachment shafts
to the attachment posts of the door.
to run for 2 -3
2
Publicidad
Tabla de contenido
