Kenmore 255.99283 Manual De Instrucciones página 5

beverage center
beverages beverage center.
beverage center
1
Temperature Adjustment
: Press this pad once and the temperature will increase 1° F/C.
: Press this pad once and the temperature will decrease 1° F/C.
The beverage center can be operated by adjusting the temperature control buttons (up arrow
and down arrow) to various settings.
The new desired temperature will flash on the display for a few seconds and then switch
back to the actual temperature which will gradually change until setpoint is reached.
The temperature range MIN and MAX is 40° - 50°F (4° - 10°C),
beverage storage.
LED light pad; press to turn light on or off.
POWER On/Off: Press this pad to power the unit on or off.
Press and POWER together for 2 seconds to convert between Fahrenheit
temperature and Celsius temperature.
Failure Codes
If "E" and "F" display, contact Sears or another qualified service center for unit repair.
If the temperature in the beverage center is too low, it will display "L".
control to a warmer setting.
If the temperature in the beverage center is too high, the control will flash "H", and an alarm will
sound for 30 seconds. One minute later, the alarm will continue to sound for another 30 seconds.
After three times, the alarm will not sound any more. You can press any key to cancel the sound
alarm.
Storing too many cans or bottles in the beverage center may cause the temperature in the chiller to
rise temporarily.
,
and Temperature Control panel.
your beverage center.
Apply a light coating of petroleum jelly to the hinge side of the door gaskets to keep the gaskets
pliable and ensure a good seal.
closed to preserve compartment coolness for as long as possible. After a prolonged power outage,
Adjust the temperature
you should clean the inside of the beverage center compartment before reuse.
always keep it in a vertical position.
beverage center
beverage center
Keep the beverage center door
remove beverages from beverage center,turn
If moving the beverage center,