Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Attach the rear of wheel tray to REAR cross-bar using the U-bolt, bracket, and plastic knobs. (Figure 6)
6.
Install the plastic pads into the bike clamp. (Figure 7)
LOADING THE BIKE(S)
7.
Place your bike into the wheel tray and raise the support arm clamp jaw to the bike down tube. Tighten
the knob firmly. Use key to lock and unlock plastic knob. (Figure 8)
NOTE: The angle between the down tube and the support arm should be approximately 90 degrees.
NOTE: Check the clamp jaw knob regularly to insure it is tight.
8.
Secure the bike wheels to the wheel tray using the straps as shown. (Figure 9)
Figure 6
90 Degrees
Figure 8
IMPORTANT NOTES:
The rack is supplied with a locking jaw knob. This is not a theft preventing devise and extra security is
recommended.
Extra accessories such as child seats, baskets and bike covers should not be used due to the increase in
wind resistance. This could cause damage to the rack, bikes, or vehicle.
Carrying items on the roof can adversely affect the handling of the vehicle, so drive slower, especially in cross
winds.
NOTE: Don't forget that the bikes on the roof increase the height requirement.
Be aware when entering underground parking or drive through fast food restaurants.
Rear Cross-bar
Down tube
63130
ONE PLACE ROOF TOP BIKE CARRIER
Plastic pad
Page 2 of 9
Figure 7
Figure 9
63130N 5-2-07 Rev A
Publicidad
