NORAUTO PREMIUM MF450 Manual Del Usuario página 52

OPERATION
1- General Safety instructions
- Check in your car's notebook that the use of boosters is not prohibited.
In this case the booster could damage the electronic system of your vehicle.
- If you are not in a well-ventilated area, please do not attempt to jump start your vehicle.
- Turn off ALL electronics in your vehicle (air conditioner, heat, radio, lights, etc.) to ensure the best
performance of your jump starter.
- Ensure key is in the "OFF" position in the ignition. For smart-key fobs (push-to start vehicles),
make sure the vehicle is completely "OFF" before jump starting.
2- Connection instructions
- Make sure that the cables are located to prevent damage from closure of doors and engine
compartment covers
- Check the polarity of the battery posts. The POSITIVE (POS, P, +) battery post usually has a
larger diameter than the NEGATIVE (NEG, N, -) post
- Follow the manufacturer's instructions to remove any insulating cover on the battery terminals.
- Connect the red positive (+) clamp to the positive terminal of the car battery.
- Connect the black negative (-) clamp to chassis or a fixed metal solid component of the vehicle or
to a part of the chassis.
- Never connect the clamp directly to the negative terminal of the battery or moving a parts.
- Always connect the connector cable and the signal cable before you start the car.
3- Using Under Standard Model
In most situation, the weak battery can fully recharge the
jump starter, follow three simple steps to get your car
started!
1. Connect your booster according to the recommendations in point 2
Connection instructions.
2. Press ON/OFF, jump starter will start to recharge itself.
Indicators show jump starter's voltage during charging.
3. After 14V indicator stops blinking , turn on engine.
51