Safco 7174 Manual De Instrucciones página 2

3
Gently slide the connector prongs of the top shelf
assembly into the TOP ends of the side panel
assemblies until it snaps into place.
TOP:
SQUARE HOLES
SIDE
PANEL
ASSEMBLIES
BOTTOM:
ROUND
HOLES
Hint: Tear off a carton flap, and use it as a guide to help the
corner connector slide past the edge of the steel, as shown.
Once the edge of the connector slides inside the steel,
remove the flap and finish pushing the connector into place.
5
Place the J Bottom Shelf (Thick) into position at the
bottom of the unit (the back has the hole in the center
of the long edge), line up all corner holes, and fasten
with D Sheet Metal Screws (two per corner).
D
7
Install remaining K Middle Shelves in desired
locations, again with center holes toward the back
(center hole in each group of five holes in back
panels will produce equally spaced shelves). Use a
sheet metal screw in each of four corners, making
sure the shelves are lined up with the proper holes.
K
7174-37: 2 of 4; Rev. 5; 07/00
TOP SHELF
ASSEMBLY
FLAP FROM CARTON
CORNER
CONNECTOR
SIDE PANEL
J
TWO SCREWS
PER CORNER
Safco Products Company, New Hope, MN 55428
4
Unfold the G Upper Back Panel (the SHORTER of
the two) and lay it out flat INSIDE between the two
side panel assemblies and toward the top shelf.
Line up the holes in the back panel with the holes in
the steel side panels. Insert H Plastic Push
Fasteners through the holes in each corner (ONLY)
of the back panel, into the holes in the side panels,
and tap the fastener heads
gently with a small ham-
mer or mallet until seated.
Unfold the I Lower Back
Panel and lay it out in the
bottom end of the unit,
with the end having two
holes near each corner
toward the BOTTOM of
the unit. Fasten with a
push fastener in each of
the TOP corners ONLY!
6
Select one of the K Middle Shelves (Thin) and
place it at the seam in the side panels. The front
edge of the shelf has a thick flange, and the back
has a center hole. The side flanges of the shelf
should rest against the UPPER side of the flanges
of the side panels. Fasten with D Sheet Metal
Screws, one at each of four corners.
IMPORTANT: Screws must
enter the round hole in the
plastic side connectors!
Hint: You may find it
easier to turn the unit
on its side to install
these screws.
8
Set the unit upright and,
from the back side, insert H
Plastic Push Fasteners into
the center shelf hole BE-
TWEEN the two back
panels. Tap gently to set
the fastener. Now insert a
fastener into the BOTTOM
center hole of the lower
back panel, and tap as
before. Finally, insert a
fastener into the appropriate
center hole for each remain-
ing middle shelf, and tap
into place.
G
H
I
NO FASTENER
TWO HOLES
K
HOLE IN
CONNECTOR
BETWEEN
BACK PANELS
H
D