Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Before beginning assembly of this product, make sure all parts are present.
Compare parts with package contents list, illustrated in figure 1.
If any part is missing or damaged, do not attempt to assemble, install or operate the product.
Contact customer service for replacement parts.
1 Head Cushion
Locking Pin
2
(Not Shown)
3 Fasteners
4 Casters
5 Head Frame
6 Middle Frame
7 Rear Frame
8 Casters
OPERATING INSTRUCTIONS
To transform creeper into seat position
Figure 2
Lock Pin
1. Locate, then unlock the spring loaded Lock
Pin by pulling out until disengaged, at the
same time flip the Head Frame and Middle
Frame upward and back towards the Rear
Frame section until the Lock Pin can engage
the Creeper Seat Locking Sleeve (Fig. 3).
Ensure Lock Pin is fully engaged.
2. Flip the Head Frame forward until horizontal.
CARE AND MAINTENANCE
Check the device every now and then for damage and the castors are securely
Wipe clean as needed.
Use only mild, non-caustic cleaner to clean the upholstery and frame.
Never add lubricant to casters !
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Figure 1
To transform seat into creeper position
Figure 3
3. Unlock the spring loaded Lock Pin by pulling
out until disengaged, then reverse steps 1, 2
to convert Creeper Seat into Creeper.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Lock Pin
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
