Maintenance And Cleaning - Parkside PABS 18-2 SL Instrucciones Para El Manejo Y La Seguridad

Operation/Cleaning/Disposal/Information
so that swarf or drill dust can be removed and the
hole and tool is ventilated.
4. Secure or fix down the workpiece (if possible) in a
clamp or vice.
5. Mark the intended position of the hole with a cen-
tre punch or a nail and select a low drill speed.
6. Drilling in metal: Use a metal drill bit (HSS). For the
best results, you should cool the bit with oil. Metal
drill bits can also be used to drill into plastic.
7. Drilling in stone: Use a circular shafted masonry
drill bit with a hardened metal tip.
8. Drilling in wood: Normally you should use a wood
drill with a centring point. For deep holes, use an
auger type bit. For large diameter holes, use a
forstner bit. You can screw small screws into soft
wood without the need for pre-drilling.
í

Maintenance and Cleaning

Do not allow any liquids to enter the tool. Use a
soft cloth to clean the housing. Never use petrol,
solvents or cleaning agents that might attack
plastic.
„ The ventilation openings must always be kept free.
í
Disposal
The packaging is wholly composed of environmen-
tally-friendly materials that can be disposed of at a
local recycling centre.
Please contact your local council office to find out
about disposal facilities for your worn-out appli-
ances.
Defective or exhausted batteries must be recycled in
accordance with Directive 91/157 EEC.
Please refer to the special safety advice in relation
to the charger and battery pack.
Return the battery and/or the equipment to the pro-
vided collection facilities.
www.kompernass.com
18 GB
PARKSIDE
í
Manufacturer's declaration
of conformity
We,Kompernaß Handelsgesellschaft mbH,Burgstr.21,
D-44867 Bochum, Deutschland, hereby declare that
this product complies with the requirements of the
following EU directives:
EC machine guideline:
(89/392 EC), (91/368 EC), (93/44 EC), (93/68 EC)
EC low voltage regulations:
(73/23/EEC), (93/68 EEC)
Electromagnetic compatibility:
(89/336 EEC), (92/31 EEC), (93/68 EEC)
Applicable harmonised standards:
Description of the device:
Cordless 2 gear drill driver PABS 18-2 SL
Bochum, 31.01.04
Hans Kompernaß
- Managing Director -
We reserve the right to make technical modifications in the course
of further development.