DeWalt DXGSE Manual Del Operador página 14

ENGLISH
ASSEMBLY - Continued
Installing and Adjusting the
Handle
Installing the Handle
1. Press and hold the handle base against the
underside of the upper shaft housing (Fig. 4).
2. Press the handle top onto the handle base
until they snap together (Fig. 4).
3. Insert the bolts (x4) into the holes (x4) (Fig. 4).
4. Tighten the bolts, but do not tighten them
completely. Use a 5/32-inch (4 mm) Allen
wrench.
Coupler
Primary Hole
Attachment
Fig. 2
Release Button
Guide Recess
Fig. 3
5. Hold the unit in the operating position (Fig. 13).
Move the handle up or down the upper shaft
housing to a comfortable location (Fig. 5).
Make sure the handle is positioned beyond
the end of the safety label (Fig. 5).
6. Tighten the bolts until the handle is secure.
14