Inspection And Maintenance - Beta 3029/2T Instrucciones

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
PERSONNEL SAFETY
• Stay alert; watch what you are doing. Do not use the jack while tired or under the influence of drugs,
alcohol, or medication.
• HANDLE THE JACK WITH THE GREATEST CARE WHILE PERFORMING ANY OF THE JOBS IT
HAS BEEN DESIGNED FOR, TO AVOID GETTING SERIOUSLY INJURED.
• Always use the following personal protective equipment:
• safety footwear;
• protective, mechanically resistant gloves.
• Make sure you are in a safe position while operating the jack, keeping proper balance at all times.
A safe working position and a proper body posture enable better control of the jack in unexpected
situations.

INSPECTION AND MAINTENANCE

Periodically carry out the following inspections in accordance with the Machine Directive and
the standards concerning checks of lifting apparatus:
• Before each use, visually inspect the jack, checking that there are no surface defects, including
deformations, cracks, rust or cuts that may prevent the jack from being properly operated.
• If the jack is not used for prolonged periods, before using it, check that it is perfectly serviceable.
• Perform extra checks following any particular events that may have caused the jack to be damaged,
thereby affecting proper operation.
• Periodically check the oil level. Remove the oil plug, check the oil level, and add oil as needed. Do not
dispose of oil into the environment.
• Use W15 oil for hydraulic jacks. Do not use brake fluid, transmission oil or engine oil, which could
cause the jack to malfunction
All maintenance and repair jobs must be performed by authorised staff; contact Beta Utensili's
repair centre, if need be. Only original spare parts may be used.
HYDRAULIC JACK USE AND CARE
• Place the jack so that the load is centred over it, at such gripping points as stated by the vehicle
manufacturer.
• Do not leave any pressure in the jack at end of stroke when there is no load.
• Store the jack in a suitable place when not in use.
• It is absolutely forbidden to make any structural changes to the jack, as these might affect its safety
characteristics.
EN I
7