Led On Charger - Cramer 82VH1000 Instrucciones De Uso

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
Pouch
See figure 8.
Accommodates
breaks and after finishing work.
Secure the pouch (1) to the waist belt only
in the positions shown.
1. Attach pouch to waist belt.
2. Insert the adapter (2).
3. Close the hook and eye fastener (3) –
the adapter is held in the pouch.
Never transport metallic, pointed or sharp
objects in the pouch. They may bridge the
contacts in the adapter and cause a short
circuit.
LED ON BATTERY
See figure 2.
The LEDs show the battery's capacity &
any problem with the battery or the power
tool being used.
Press button (1) to activate the LEDs –
the display goes off automatically after
5 seconds. The acoustic signal must
sound briefly when the button is pressed
(to confirm function) – see also "Acoustic
Signal".
During Operation
LED will indicate the battery capacity.
If the LED glow continuously / flash
When the pack goes wrong, it will show
different fault codes.
E0 – BMS fault
E1 – Over-current (discharging)/(charging)
E2 – Communication fault (with charger or
external tools)
E3 – Over-voltage of cell
E4 – Low-voltage of cell
English (Original instructions)
adapter during
WARNING
E5 – Bad consistency of cell
E6 – External tools abstract electricity
work
HI – Over temperature of battery
Lo – Low temperature of battery
TRANSPORTING THE BATTERY
Disconnect the battery from the power tool
– even when carrying it for short distances.
This avoids the risk of accidental startup.
Carry the battery by the handle or on your
back.
In vehicles: Properly secure the battery to
prevent turnover and damage.
Special precautions must be taken when
transporting a damaged or malfunctioning
battery. To reduce the risk of accidents,
always contact your CRAMER servicing
dealer before transporting such a battery.
CHARGING THE BATTERY
NOTE: The battery is not shipped fully
charged. It is recommended to fully charge
before use to ensure that maximum run
time can be achieved.
See figure 6.
1. Plug the charger into an AC power
outlet.
2. Connect the battery with the adapter,
then insert the adapter (1) into the
charger (2).
LED ON BATTERY
The words showing the current battery
capacity will be blinking.

LED ON CHARGER

See figure 3.
These are
5
WARNING
diagnostic chargers. The