Eaton Converge Serie Instrucciones Para La Instalación página 5

10
Cut powered aircraft cable above gripper using tin snips leaving
approximately 3 inches of extra cable. Insulate cables using heat-
shrink tubing (provided) or electrical tape (not provided). Ensure
that cables do no contact any metal surfaces.
12
For continuous runs: Install remote boxes and fixtures in ceiling
as indicated in the individual install instructions. Use length
configuration chart to determine layout of run.
14
Insert screws into joiner and tighten
Finish joining by inserting screws near the joint.
5
EATON
IL524011EN
Installation instructions
11
Replace and attach electrical cover re-installing with screws.
Re-install the trim cover.
13
Slide fixture onto joiner
Join fixtures by sliding joiner into consecutive fixtures like shown
above.
15
Energize fixture to ensure proper functionality. Remove protective
wrap.