Beta 599 DGT/20 Instrucciones página 13

STEP 1: UNIT SELECTION
Presetting Unit: Nm
Press
Unit Selection: in-lb
Press
Unit Selection: ft-lb
Press
Unit Selection: kg-cm
STEP 2: SET TORQUE VALUE
Presetting Torque Value
Increase Max. Torque Value
Decrease Max. Torqur Value
Note:
1. If appears, that means more than 110% torque as stated in the specifications has been
applied to this wrench.
The wrench will start working again after a few seconds; however, it should be checked for
calibration at a Beta authorized centre as soon as possible.
2. The function "Unit Selection" is sequential.
Press
Press