Dolmar MB-CS Manual De Instrucciones Original página 11

2. Attach the brushes or sweep drums to the brush
unit or sweep drum unit, and then attach the clips.
NOTICE:
When attaching the brushes, be sure
to attach them with the Makita/Dolmar logo facing
outside.
NOTICE:
When attaching the sweep drums, be
sure to attach them in the direction shown in the
figure, so that the sweep drums and the gear case
mesh with each other.
1
► 1 . Sweep drum 2. Gear case
Lubricating moving parts
NOTICE:
Follow the instruction of the fre-
quency and amount of grease supplied. Otherwise
insufficient lubrication may damage moving parts.
Gear case:
CAUTION:
Do not apply grease when the
gear case is hot. Hot gear case can cause burn
injury.
Fill approx. 30 ml of grease (Makita grease SG No.0)
through the grease port evenly every 25 hours of
operation.
With the supplied hexalobular wrench, remove the bolt
near the lubrication marking on the gear case. Loosen
the bolt on the other side so that the air in the gear case
can be released when applying the grease.
After applying the grease, be sure to tighten the bolts.
2
► 1 . Bolt 2. Gear case
Drive axle:
Apply grease (Makita grease SG No.0) every 25 hours
of operation.
When storing the attachment separated from the power
unit, put the cap onto the end of the shaft.
11 ENGLISH
1
2
NOTE: Genuine Makita/Dolmar grease may be pur-
chased from your local Makita/Dolmar dealer.
Storage
WARNING:
Follow the warnings and precau-
tions in the chapter "SAFETY WARNINGS" and
the instruction manual of the power unit.