Superior SVEVA Manual De Instrucciones página 2

MARCELLA-SVEVA REMOTE CONTROL SET
If the remote control set is installed then it will no longer be possible
to install the GPRS module and vice versa.
- Remove the right side panel and the front panel, as described in the
"INSTALLATION" section to be found in the "INSTALLER INSTRUCTIONS"
of the cladding booklet.
- Remove the DB9 port connector [A] from its seat in the electronic board.
(Fig. 1)
- Connect the cable with receiver [C] to the electronic board and the DB9 port,
as shown in the wiring diagram. (Fig. 2)
- With the help of pliers, remove the fl ap [B] located at the bottom right of
the stove. (Fig. 3)
- Insert the remote control receiver [C] into the newly created slot. Fit the
receiver [C], the bracket [D] with the screw [V] provided in the set.
- Fit the bracket [D] by inserting the side tab into the lower part of the right
front trim of the stove and secure it with the screw [V] provided in the set.
(Fig. 4)
- When installing align the spherical rounded part of the receiver [C] with the
central slot in the bracket [D].
Incorrect alignment can impair remote control reception.
- Check that the remote control receiver cable cannot come into contact with
parts of the stove that may become hot when the stove is in use.
- Refi t the previously removed cladding in the reverse order to removal.
- Use the remote control functions as described in the section "USE" in
the instruction booklet for "INSTALLATION, USE AND MAINTENANCE"
accompanying the product.
Fig. 1
Fig. 2
C
Fig. 3 B
Fig. 4
D V
C
DT2011883-01
A
DT2032445-0
A
DT2032447-00
DT2032447-0
B
DT2032777-0
V
D
DT2032778-1