Alcad PDK-42400 Manual Del Usuario página 15

VIDEOPORTERO DIGITAL -
Funcionamiento - Operation (Concierge unit deactivated) -
Configure the entrance panel of the external point of entry as the external panel (E) (See "Configuration of exterior entrance panel (E)", page
29). Configure the entrance panel of each building as the main panel (Leave the J1 jumper installed). This entrance panel will be activated when
the auto switch-on function is used from the monitor.
The function activating the electric lock from the entrance panels only remains enabled in the external point of entry.
SYSTEM ON STANDBY
The monitors are inactive (communication with the entrance panel and door opening functions are disabled). If the handset of a monitor is lifted,
an uninterrupted tone will be heard. It is possible to activate the monitor's auto switch-on system.
SYSTEM ACTIVE.
Only the monitor whose code is identical to the code which has been entered will receive the call. Confirmation of the call on the entrance panel.
If the handset of another monitor in the same building is picked up, intermittent tones will be heard and the auto switch-on function will not
operate. If the handset of the requested monitor is off the hook or if the code does not correspond to any monitor, the panel will emit intermittent
tones. When several monitors are installed in the dwelling, all of them receive the call. The first monitor to be answered will establish communication
with the the entrance panel.
Time setting to answer: At the external point of entry; configurable (Position 7 from the configuration menu). In buildings inside the estate;
consult datasheet of the audio unit.
Maximum time setting for conversation: At the external point of entry; configurable (Position 6 from the configuration menu). In buildings
inside the estate; consult datasheet of the audio unit.
During the answering and conversation periods, the panels of other buildings remain on standby until a call is made. If the call is made from
the external point of entry, the panel display will show the code which has been entered. The entrance panel of the building where the monitor
is located remains deactivated (blocked) The red indicator will blink.
( j1
standby.
.
,
( 6
stsndby
.
).
).
(
,
.
.
, ,
,
,
,
,
.
).
.
).
.
:
:
,
( 3-
,
(
( ) ( .
,
,
.
.
.
:
:
),
)
.29 "
.
.
).
.
.
,
(
( ).
7