ALLEN GROUP INT'L INC FF27428 Manual Del Usuario página 8

SAFETY PRECAUTIONS
This fountain may be used outdoors only.
Place your fountain in a location where any water spills or splashing will not reach any other electrical equipment or cause
damage.
Choose an appropriate location before installing the fountain. Empty the base before lifting, DO NOT lift, push or drag the
base to relocate the fountain when it's filled with water.
Excessive weight or pressure on any of the fountain sections may cause it to tip or fall over. Keep pets and children away
from any of the fountain sections.
Some splashing may occur. To avoid injury from electrical shock, observe basic safety precautions and comply with the
following instructions:
The pump on your fountain has no user serviceable parts.
service the pump
pump maintenance guide for cleaning.
Install the fountain pump correctly
1.
2. DO NOT allow the pump to run dry.
An adult should supervise children when they are around the pump.
3.
4. Use the proper power source as indicated on the pump label.
5. Equip the electrical power for the pump with a ground fault circuit interrupter (GFCI).
6. If the entire fountain falls into the water accidentally, turn off the circuit breaker immediately.
7. If any leakage occurs around the pump housing, turn off the circuit breaker immediately and have the pump serviced by
a registered technician.
8. Do not operate the fountain if the pump has been dropped or has a damaged power cord or plug.
9. If the plug or your wall receptacle gets wet due to water dripping down the power cord or for any other reason, do not
remove the plug from the wall outlet until the circuit breaker is turned off.
NOTE: Allow the pump power cord to hang at a lower level than the wall outlet to
form a "drip loop". This will help prevent water from dripping down the power cord
and getting into the wall outlet.
10. Always unplug the fountain pump and any other independent electrical accessories
from the outlet when not in use and before cleaning or replacing parts.
11. Disconnect the power cord from the outlet by holding the plug, not by pulling on the power cord.
12. Do not expose the pump to direct sunlight or to low temperatures for any period of time.
13. Keep the power cord away from high temperatures or heat sources.
14. Use only a UL-approved extension cord of the correct rating to avoid overheating.
15. Do not use attachments which are not provided by the manufacturer, since they may cause an unsafe condition.
16. Do not use the pump for anything other than its intended use.
17. This fountain pump is not intended for commercial use.
PDF created with pdfFactory Pro trial version
. Do not open the sealed pump housing as this may result in electrical shock. Refer to enclosed
before operating it.
Only an authorized service representative should
www.pdffactory.com
GFCI DRIP LOOP
3