ASSEMBLY INSTRUCTIONS
WARNING
• To safely put up or take down the canopy you must use two or more able adults.
Set Up
1. Place your frame (A) in the center of the set-up
area. With a partner on the opposite side of the
frame, hold on to the two outer legs and lift slightly
for clearance. Take a few steps back until you
extend the frame (A) to a full arm's length -
approximately 4 feet. To improve the opening and
closing action of your frame (A), you may spray
some silicone lubricant on the outer legs.
2. Place the canopy (B) over the top of the frame
(A). Use the hook-and-loop straps to secure each
corner of the canopy (B) to the upper position of
each leg.
3. Hold the bottom of the middle frame (A) section
where it forms a "V." Lift slightly and slowly walk
backward until the frame (A) is fully extended.
Take care to avoid pinching your hands or fingers.
4. At each corner, hold the leg of the frame (A)
with one hand and lift the slider with the other
hand. Push the locking button in while pulling the
slider up until the button pops through.
4
1
2
3
4