Technical Data - Beta 1498/120A Instrucciones

INSTRUCTIONS FOR USE
• Do not use the battery charger when damaged, to avoid the risk of electric shocks; do not try to open
or modify it.
• Connect the battery charger to the mains socket, making sure that the mains voltage matches that
stated on the power supply device. (See TECHNICAL DATA table)
• Do not cover the battery charger when using it. Allow adequate space for ventilation.
• Do not use the battery charger in humid or wet environments; do not expose it to rain. Wet and
contaminated environments increase the risk of electric shocks.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING BATTERY CHARGER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING BATTERY CHARGER
Additional personal protective equipment to wear according to the values found in the
environmental hygiene/risk analysis survey if the values exceed the limits under current
regulations.

TECHNICAL DATA

FOR USE WITH BATTERIES
RATED VOLTAGE
CHARGING VOLTAGE
ABSORBED POWER
BATTERY CHARGING CAPACITY
BATTERY HOLDING CAPACITY
CLAMP CABLE LENGTH
CLIP CABLE SECTION
DEGREE OF PROTECTION
POWER SUPPLY CABLE LENGTH
DIMENSIONS
WEIGHT
SIGNALLING LEDS
The front panel of the battery charger accommodates 15 LEDs, including 4 battery status LEDs,
indicating the following:
• "Full": battery is charged, and is in charge maintenance status
• "Charging": battery is charging
• "Fault": battery is damaged
• "Reverse": polarity reversal
• 1 battery charge status LED, "led ON" (blue colour)
12V Wet - Agm - Lithium LiFePO4
110V-240V 50/60Hz
12V max
1800 Watt
10÷1200 Ah
10÷3000 Ah
2.7 m
25 mm
2
IP20
1.7 m
350x450x150 mm
8.8 kg
EN
13