Channel Switch; Getting Started; Insert Batteries; Name Tags - Oregon Scientific RMR500 Manual De Usuario

1. LCD display
2. LED status indicator
3. Wall mount hole
4. RESET hole

5. CHANNEL switch

6. Battery compartment

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG
3).
3. Press RESET after each battery change.
LOCATION
Outdoor temperature/
humidity area (THGN500)
Main unit environment area
Remote sensor area
(THGR122N)
Clock and calendar area
(or optional sensors area)

NAME TAGS

Name tags can be inserted in the main unit as in Fig. 1.
MEANING
Outdoor sensor battery low
Main unit batteries low
Remote sensor batteries
low
Optional sensors batteries
low
There are 10 name tags provided in this package, with 7
blank tags and 3 tags printed as "MAIN UNIT", "TIME" and
"CALENDAR". You can write in the blank tags the name of
the location where THGR122N and other optional sensors
are installed.
NOTE
If optional sensors are installed, "CALENDAR" and
"TIME" tags will be replaced.

REMOTE SENSORS

This product can work with up to 4 sensors at any one time
to capture temperature and relative humidity readings in
various locations.
2 remote sensors (THGN500 and THGR122N) are provided
in this package, while 2 more optional wireless remote
sensors can be purchased separately.
To set up the remote sensor:
1. Open the battery compartment and insert batteries,
matching the polarity.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the remote sensor within 30 m (98 ft) from the
main unit.
NOTE
Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.
4