Magellan RoadMate Manual Del Usuario página 13

Setting Zoom Levels
As you zoom out in 3D, the display will switch
to 2D at higher zoom levels.
Tap + or - at the bottom of the Map screen to
set the desired zoom level.
Note: Zoom levels are limited in 3D mode.
Panning on the Map
1. Slide your finger or a stylus across the
Map screen. The map screen changes to
Pan mode.
2. Tap when you're finished, and the
map returns to your current position.
Routing to a Panned Position
1. Pan the map until the location you want to
route to is displayed.
2. Tap on the map at the point you want to go
to. A red push pin, along with information
about the point chosen, will be displayed
at the top of the screen.
3. Tap in the top left corner.
4. Define what to do with this new route
point if an active route already exists:
Replace Destination: The next destination
is cleared and replaced with the one
selected from the Pan screen.
Go There Now: The selected location is
inserted in the route as an intermediate
destination before the next destination.
Add To Trip: the selected destination is
added to the end of the current trip.
5. Tap to return to the Map screen and
begin navigating.
Note: If the selected position doesn't match
an existing street address (i.e. the destination
is not along a road or street that is stored in
the map database), you will be stopped on
the road closest to your destination, and a
dashed line to your final destination will be
displayed on the map.
Current Location Screen
The Current Location screen displays the
approximate address of your current position,
the next and previous intersections, your
latitude, longitude, heading and elevation.
Accessing the Current Location Screen
Tap the Current Position icon from the Map
screen.