Promise Technology SUPERTRAK EX4350 Guia De Inicio Rapido página 6

SuperTrak EX4350 Quick Start Guide
LED Pins
Attach one SATA data cable to each disk drive. Then attach the other ends of the
cables to the connectors on the SuperTrak card (above).
2. Attach the Y-cable power splitters to each of the disk drives
3. Optional. Attach cables from the LED pins on the SuperTrak card (see
above) to the activity LEDs in your enclosure.
The Promise SuperSwap enclosure has its own internal LED connections.
SuperSwap does not use the individual LED connectors shown above.
Connect the SATA data cables so the channel numbers on the SuperTrak
card match the drive carrier numbers in the enclosure. See the SuperSwap
User Manual for additional information.
Step 4: Create a Logical Drive
You will now use the onboard SuperBuild BIOS utility to create a logical drive with
the attached drives. Even if you plan to use the WebPAM software to manage
your logical drive, you can still create your first logical drive using the SuperBuild
Utility, as described here.
For an explanation of the logical drive concepts, see Chapter 6 of the SuperTrak
EX4350 User Manual on the CD.
Ch3
Ch1
Ch2
SuperTrak EX4350
SMBus connector
for SuperSwap
Ch4
SuperTrak EX4350
6
BBU module
connector