GM REV25MR08 Instrucciones De Montaje

Full Size Truck and SUV Navigation Radio
Kit
Included in the Navigation Radio Kit
Navigation Radio
Navigation Wiring Harness
Global Positioning System (GPS) Antenna
Navigation Data Disc
Navigation Radio Owner's Manual
Required tools
Small Flat Screwdriver
7mm Socket
10mm Socket
Flat-bladed plastic trim tool
SPS Programming
Important Denali Vehicle Information: In addition to the
navigation wiring harness, 19132237, navigation radio kits
installed on Denali vehicles may require an additional voice
prompt wiring jumper, 19202083. Voice prompt wiring jumper,
19202083, is only needed if the vehicle was built without the
voice prompt wiring content. If the vehicle was not built with the
voice prompt wiring content then the voice prompt wiring jumper,
19202083, must be ordered and installed to complete the
navigation radio installation. Follow installation steps 1-13 to
verify if the voice prompt wiring jumper, 19202083, is needed
without removing the existing radio. The voice prompt wiring
jumper is typically needed with GMC Pick Up Trucks and SUV,
Denali vehicles without rear seat entertainment (-U42).
The navigation voice prompt wiring jumper is only needed on
GMC Denali vehicles (&Z88&Y91). It may be used with or
without the accessory navigation harness, 19132237, provided
with the navigation radio kit.
Included in Denali Navigation Voice Prompt Kit
Voice Prompt Wiring Jumper, P/N 19202083
Tie Straps (Qty:6)
Important Hybrid Vehicle Information: For vehicles with
Hybrid Propulsion RPO, &HP2, the accessory wiring harnesses,
19132237, and 19202083 do not need to be installed into the
vehicle. The navigation wiring content is given away from
production. For Hybrid vehicles, perform installation steps 1-8,
16-30, 34-52, 80-97, and 102-121.
Full Size Truck and SUV Navigation Radio Kit
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 10AP06
WHITE 16 POUND NON-BOND
01FE07 Revised - Jonathan Ward
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
08AU07 Revised - Jonathan Ward
ING TEMPLATES.
02DE07 Revised - Jonathan Ward
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
25MR08 Revised - Jonathan Ward
CATIONS.
REVISION
Initial Release - Jonathan Ward
Procedure:
Important: Please review this entire procedure before attempt-
ing to install navigation radio kit.
NOTE: Before removing existing radio record preset stations
from all bands.
1. Disconnect negative battery cable.
2. Turn off all the lamps and accessories.
3. Turn the ignition OFF.
4. Open the hood.
5. Loosen the negative battery cable nut.
6. Remove the negative battery cable from the battery terminal.
7. Reposition the negative battery cable away from the battery.
8. Wait one minute before working on vehicle.
Go to Step 16 for Hybrid (&HP2) vehicles only.
9. Remove cup holder in center console bezel.
10. Use a flat-bladed plastic trim tool to release the retainer
clips along the rear edge of the bezel. See Figure 1
FIGURE 1
11. Lift the bezel out of the center console assembly.
12. Find the instrument panel/center console wiring harness
inline connector located down in the console assembly. The
inline connector will be below the bezel that was just re-
moved.
PART NO.
REV25MR08
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
Full Size Truck and SUV Navigation Radio Kit
PART NO.
19153971
6200 Grand Pointe Dr., Grand Blanc, MI 48439
19153971
SHEET
1
SHEET
1 30
OF
30
OF