Publicidad
Idiomas disponibles
Idiomas disponibles
USED AS A CLEANER FOR FLOORS/CARPETS
•
Fully unwind the power cable (11). To do so, turn the upper cable hook (10A) downwards.
•
Secure the cable in the slot of the upper cable hook to prevent the cable from hindering the cleaning
operations.
•
Connect the power cord (11) to the mains.
•
Press the on/off button (4). The steam ready LED (6) will light up BLUE and after a few seconds
it will become RED so as to indicate that the boiler is ready for use. [Fig D1]
•
Rest one foot on the brush (8) and pull the handle (1) toward you to tilt the Steam Mop body.
[Fig D2]
•
Produce steam by briefly pressing the steam mop button (2). [Fig. D3]
DO NOT emit steam continuously so as to not to wet the surface that is to be cleaned excessively.
•
•
The steam takes a few seconds to penetrate through the cleaning cloth.
•
Rub the surface that is to be cleaned by inclining the product to about 45° [Fig. D4]
•
Switch the product off by pressing the on/off (4) button again [Fig.D1]
•
Let the product cool.
WARNING: SCALDING HAZARD
Before removing the cloth (16L), after use, ALWAYS switch off the steam cleaner
and wait a few minutes until the brush (8) has cooled.
•
Press a corner of the cloth (16L) with one foot and lift the steam mop to remove the cloth from
the brush (8). [Fig. D5]
CLEANING STUBBORN STAINS
If there are stubborn stains on hard surfaces you can remove them by using the Stain removal brush (8A).
With the steam cleaner in a vertical position and the brush locked at 45°, rub the stain with stain removal
brush (8A) on the rear part of the brush (8). [Fig. D6]
TO RENEW RUGS/CARPETS
•
Place the Microfibre Cloth (16L) on the floor with the Velcro side facing up and place the brush (8) on
it and press lightly, making sure to cover the entire surface of the brush. [Fig. B3]
•
Place the Rugs/Carpets support (9) on the ground.
•
Insert the brush (8) in the front part of the rugs/carpets support and press the steam mop until the
Rugs/Carpets support (9) attaches completely to the brush (8) [Fig. D7]
•
The rugs/carpets support allows the steam mop to slide easily on surfaces such as rugs and
carpets with short hair.
•
Fully unwind the power cable (11). To do so, turn the upper cable hook (10A) downwards.
•
Secure the cable in the slot of the upper cable hook to prevent the cable from hindering the
cleaning operations.
•
Connect the power cord (11) to the mains.
•
Press the on/off button (4). The steam ready LED (6) will light up BLUE and after a few seconds
it will become RED so as to indicate that the boiler is ready for use. [Fig D1]
•
Rest one foot on the brush (8) and pull the handle (1) toward you to tilt the Steam Mop body.
[Fig D2]
•
Produce steam by briefly pressing the steam mop button (2). [Fig. D3]
DO NOT emit steam continuously so as to not to wet the surface that is to be cleaned excessively.
•
DO NOT dose the amount of steam excessively during use on rugs/carpets.
•
•
The steam takes a few seconds to penetrate through the cleaning cloth.
•
Rub the surface that is to be cleaned by inclining the product to about 45°. [Fig. D4]
USE
EN
13
Publicidad
