Height-Adjustment Of The Blade Guard; Adjusting The Tilt Of The Worktable - Zipper Maschinen ZI-BAS205 Instrucciones De Servicio

ADJUSTMENTS

Height-adjustment of the blade guard

Adjusting the tilt of the worktable

The following steps are necessary to adjust the cutting angle:
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BAS205 / ZI-BAS25046
 Mount the bench angle gauge (AG) with the two
 Close the lower front door (F).
 Fix the worktable with three screws M6x16,
 Fix the u-shaped clamp (K) with two screws
The blade guard protects against unintentional
contact with the saw blade and against flying chips.
 ZI-BAS205: loosen the locking screw (LS) by
ZI-BAS205  To adjust the height between blade guard and
 ZI-BAS205: retighten the locking screw (LS) by
locking screws (LS).
three washers and three nuts (M6) to the bench
angle gauge (AG).
(M6x20) and two nuts (M).
turning it counter clockwise.
workpiece, turn the hand wheel (H) until the
desired height is reached.
ATTENTION: Always lower the upper saw band
guide as close as possible (max. 3 mm) to the
workpiece.
turning it clockwise.
 After loosening both locking screws
(LS), the work table tilts steplessly
through 45° to the blade.
 By means of the angle scale (AS)
the inclination angle can be read off
the indicator (I).
 Retighten the locking screws (LS)
after adjusting the inclination of the
worktable.
46