Cleaning, Maintenance, Storge, Disposal; Cleaning; Maintenance - Zipper Maschinen ZI-BAS205 Instrucciones De Servicio

CLEANING, MAINTENANCE, STORGE, DISPOSAL

18 CLEANING, MAINTENANCE, STORGE, DISPOSAL
Handling the machine with the power supply on, may lead to serious injuries or even
death. Always disconnect the machine from the power supply before cleaning,
servicing or maintenance work and secure it against unintentional reconnection!

Cleaning

Never clean the band saw blade or the band saw rollers with a brush held in the
hand or with a scraper while the machine is running. Always wait until the machine
has come to a complete standstill!
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil.
Subsequently, regular cleaning is a prerequisite for the safe operation of the machine and its
long service life. Therefore, clean the device after each use of chips and dirt particles.

Maintenance

Danger due to electrical voltage! Handling the machine with the power supply
up may result in serious injury or death. Always disconnect the machine from the
power supply before servicing or maintenance work and secure it against
unintentional restart!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
Intervall
Before operating the
machine
After every use of the
machine
Monthly
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BAS205 / ZI-BAS25051
WARNING
CAUTION
NOTE
WARNING
Component Measure
Safety devices Check the condition
Nuts, Bolts Check if securely tightened
Drive belt Check the condition. If necessary tension it.
Saw band Check the condition. If necessary replace it.
Machine Clean the machine from chips and sawdust.
Wheel housings Vacuum off chips and sawdust
Lubricate the saw blade guide slightly with acid-
Saw band guide
free lubricating oil
Thrust bearing Keep guide discs and the thrust bearing free
Guide discs from deposits
Saw band Slacken the saw blade
Drive belt Check the condition. If necessary replace it.
Security stickers Check the condition. If necessary replace them.
Table insert Check the condition. If necessary replace it.
Thrust bearing Check the condition and replace them replace if
Guide discs they are worn out.
51